中文版
Location: Home > Product Series> Profile Controlling & Plugging

ZND-5 Guangya Gel for Oil-Gas Field



Guangya Plugging Agent ZND Series and the matching techniques, is aimed at solving the problems of large loss, loss of return or small return in fracture, cavern or broken zones, and the problems that the bridge plugging or PWD(plugging while drilling) could not solve. The product can effectively and lastingly plug the “thief layer” existing in water flooding reservoir and chemical flooding reservoir, plug deep cracks and broke formation, and stop the underground fluid flowing to the surface.

Application

Main components

Watersoluble polymer

Appearance

White or Yellowish Particles & Powders

Particles with Sizes of 0.106 mm-1.180 mm (%)

≥80.0

Solid Content (%)

≥88.0

Dissolution Time (h)

≤4.0

Viscosity (in 12000 mg/L solution) (mPa•s)

≥15000

One-minute gel strength (before Aging)(Pa)

≥15.0

One-minute gel strength (after Aging)(Pa)

≥20.0



ZND-5 offer the following advantages


1)Before gelling

Good injection performance;

Excellent shearing resistance;

Strong intermolecular affinity capacity

Good anti-dilution property and front stability;

Ability to maintain overall slug advancement;

The bridging group can resist flowing interference and its position orientation ability is strong, which can prevent the failure of gelling.

The resistance can be automatically increased when the solution flows. So, the threshold pressure at deep pore throat is high enough to reduce the linear flow rate and suppress the coning in high permeability channels

Possessing the fluid characteristics with reversible structure;

Strong anchoring ability with pore surface;


2) After gelling

High strength & Good elasticity;

Strong plugging ability;

Long-term stability;


3) ZND-5 is specially suitable for profile control and water shutoff operation in large penetration bands and channels caused by fractures or long-term water injection. It is also suitable for forming chemical “separating board”;


4) High concentrated ZND-5 solution ( >3000 mg/L) could obtain gel properties without crosslinking, thus, it is suitable for special profile control in bio-oil flooding where profile control agent is needed but the toxic-to-bacteria crosslinking agent is forbidden. It is also suitable for deep and large-dose profile control especially when gelling time is hard to control.

Usage

The product can be applied together with a variety of crosslinking agent to form gel or thin gel. The recommended dosage is 0.05%-0.8%.

If used for profile control in non-crosslinking system, the suggested dosage is greater than 0.5%, preferably greater than 0.8%.



Foroil Introduction


Copyright © Sichuan Guangya Polymer Chemical Co.,Ltd.